Water sampling equipment, instruments, environmental sampling supplies, hazardous gas detection meters
Water sampling equipment, instruments, environmental sampling supplies, hazardous gas detection meters













Rentals Introduction page with link to rentals page
Eon products specifications
Key word search of Eon site
Eon Products company profile
Phone, FAX, mailing addresses, and e-mail addresses
Eon Slogan
Eon Catalog
Bladder Pumps
Multi-Parameter Testers
pH, Conductivity, TDS, Temperature
Our Combo Tester has dual display that shows pH or EC/TDS and temperature simultaneously. Features automatic temperature compensation, automatic shut-off, & replaceable pH cartridge. With the Combo Tester, pH calibrates at 1 or 2 points, and EC/TFDS calibrates at 1 point.

Ordering Information
WQM 120
Pocket Meter Combo; pH Ec TDS
WQP 570
Replacement pH Sensor for WQM105 & 120
WQS 125
Cal Solution Packets; Cond 1413 uS/cm
WQS 190
Cal Solution Packets; pH 4& 7
WQS 181
Cal Solution Packets; pH 10 Buffer
FSB 215
Replacement Batteries 1.5V Disk (4 Req'd)
pH, ORP, Conductivity, Temperature
The Water Test™ Meter is an economy meter suited for sample screening or non-critical measurements of four key parameters. The meter has four built-in electrodes exposed at the bottom of the unit. Immerse the bottom of the meter in fluid and read the digital display. With this meter, pH and Conductivity can be independently calibrated at one point. This model is dependable but not as rugged for field use as higher priced units.

Ordering Information
WQM 150
Water Test Meter: Cond, pH, ORP, Temp
WQS 170
Cal Solution; pH   4 Buffer
WQS 175
Cal Solution; pH   7 Buffer
WQS 180
Cal Solution; pH 10 Buffer
WQS 160
Cal Solution; ORP 200 to 275mV
WQS 120
Cal Solution; Cond 1413 uS/cm
WQS 196
Cal Solution; Electrode Cleaning
FSB 215
Replacement Batteries 1.5V Disk (4 Req'd)
pH, Conductivity, ORP, TDS, Resistivity, Temperature
The UltraMeter is a high quality, durable, hand-held, multi-parameter meter that is available in models to measure four to six parameters. Sample water is poured into a small sample chamber on the meter, and the results are displayed on the digital display. These meters are rugged and waterproof, and they float, making them excellent for field use.

Ordering Information
WQM 175
Ultra Meter 3P; pH, ORP, Temp
WQM 177
Ultra Meter 4P; Cond, Res, Temp, TDS
WQM 179
Ultra Meter 6P; Cond, pH, ORP, Res, TDS, Temp
WQS 170
Cal Solution; pH   4 Buffer
WQS 175
Cal Solution; pH   7 Buffer
WQS 180
Cal Solution; pH 10 Buffer
WQS 160
Cal Solution; ORP 200 to 275mV
WQS 110
Cal Solution; Cond 1000 uS/cm
FSB 218
Replacement Battery, 9-Volt (1 Req'D)
pH, Conductivity, TDS, Temperature
Our 4-Parameter Meter is an economically priced, waterproof meter and multi-function probe for testing pH, Conductivity, TDS and Temperature. Two-button operation allows selection of conductivity range, calibration buffers, and temperature scale. User can select TDS from a range of TDS factors, temperature coefficients, and standardized buffer recognition values. Includes: Probe, Batteries, and Hard Case.

Ordering Information
WQM 205
Meter & Probe: pH, Cond, TDS, Temp w Case
WQS 170
Cal Solution; pH   4 Buffer
WQS 175
Cal Solution; pH   7 Buffer
WQS 180
Cal Solution; pH 10 Buffer
WQS 110
Cal Solution; Cond 1000 uS/cm
FSB 208
Replacement Batteries, 1.5V AA-Cell (4 Req'd)
WQM 206
Meter & Probe: Cond, TDS, NaCl, Temp w Case
pH, ORP, Temperature
The 3-Parameter Meter tests pH, ORP, and Temperature. It can be used for the most rigorous environmental testing, and the sensor-check feature allows the user to determine if the sensor is in good condition. The meter is waterproof and features two-button operation and large dual digital display that shows pH or ORP and temperature at the same time. Temperature measurement is built into the pH/ORP sensor.

Ordering Information
WQM 210
Meter & Probe: pH, ORP, Temp w Case
WQS 170
Cal Solution; pH   4 Buffer
WQS 175
Cal Solution; pH   7 Buffer
WQS 180
Cal Solution; pH 10 Buffer
WQS 110
Cal Solution; Cond 1000 uS/cm
FSB 208
Replacement Batteries, 1.5V AA-Cell (3 Req'd)
Conductivity, Level, Temperature
Our newest Conductivity Meter is ideal for profiling down-hole conductivity and temperature. Use it for saltwater intrusion investigations, tracer studies, and for tracking changes in a basic monitoring parameter. The meter is mounted on a Solinst reel and precision flat tape. The conductivity sensor uses platinum electrodes to provide accurate readings that are displayed, with temperature, on the LED screen. A light and buzzer indicate water contact. Level is read off the tape.

Ordering Information
WQM 200
Conductivity, Temperature, Level Meter (Specify Length)

EON Products, Inc.  ·  Toll-Free: (800) 474-2490